Can you stack two hand held programmers?

well everytime i post something nobody ever reply must be because i dont have many posts

I dont think you can stack to hand held programmers.... you can stack a chip and a hand held programmer though. just be careful if you do you will more than likely limp your tranny pretty quick. by chip i mean something like edge or banks.

also try using the search tool might help out a bit. Use to have the same problem but then somebody told me about the search and it made my life a little bit easier. :)

i stacked banks and superchip, never again, all i have to show for it is a piston hangin on the wall lol

You can stack programers but it is a waste of money and time. We don't drive Cummins stacking is for them. We have EFI we do not need to stack.

You can stack programers but it is a waste of money and time. We don't drive Cummins stacking is for them. We have EFI we do not need to stack.

yes :eek: dont learn the $7300 way like i did :D

You can not stack to hane held programmers because the first one that you load ont to your ecm will store the stock info and will lock the VIN code into that programmer. If you go to stack the 2nd programmer it will just say unable to read VIN.

Not worth the problems that will come from trying this. Just get a PPE or EFI setup and be done with it.