|
monsterD 05-15-2009, 10:17 PM got a used (working) edge evo from a fellow member that was more than helpful. but when i hooked it up and plug everything in correctly it doesnt light up to work. any comments or suggestion will help! thanks jeff HDpullingpower 05-16-2009, 08:46 AM Check your fuse for the OBDll port...maybe blown, the Edge gets it's power there. WormyLBZ 05-16-2009, 09:39 AM Check your fuse for the OBDll port...maybe blown, the Edge gets it's power there. Check cig.lighter fuse monsterD 05-16-2009, 04:20 PM okay so i check all my fuses and the cig light is blown. put a new one it and it blow right away so this means theres a short in the line somewhere correct? any easy way going about find where the short is? jeff bikerdan 05-16-2009, 04:36 PM Have you tried a fuse with the cig lighter removed? monsterD 05-16-2009, 10:16 PM okay well i got it to work with the cig lighter un plugged. but now since i ran it for maybe 20 minutes and turned it off. for some reason it doesnt want to work until i unplug the egt probe. my truck is also pretty hot at like 175 degrees. any insight? bikerdan 05-16-2009, 11:46 PM 175 deg on what? monsterD 05-17-2009, 12:30 AM 175 was my motors temp.. CRASHNBURN 05-17-2009, 02:53 PM okay well i got it to work with the cig lighter un plugged. but now since i ran it for maybe 20 minutes and turned it off. for some reason it doesnt want to work until i unplug the egt probe. my truck is also pretty hot at like 175 degrees. any insight? Maybe you probe is bad.. Does everything work without the probe attached? hondarider552 05-17-2009, 06:07 PM 175* isnt even the operating range.. your fine. monsterD 05-18-2009, 01:26 AM Maybe you probe is bad.. Does everything work without the probe attached? the program didnt come with a probe so i had to buy it new. but it in correctly and ran good witht he probe for 30 minutes. then when i turned it on, no work. unplug the probe and it works. so it must be the probe right? CRASHNBURN 05-18-2009, 01:29 PM the program didnt come with a probe so i had to buy it new. but it in correctly and ran good witht he probe for 30 minutes. then when i turned it on, no work. unplug the probe and it works. so it must be the probe right? It could be a bad probe. If it is Edge will take care of that.. Does it do that each time? What does it do if you run it for 30 minutes without the proble? monsterD 05-18-2009, 03:40 PM Oh It Runs Just Fine Without The Probe. And Yes Everytime It Will Turn Off If The Probe Is Plugged In. bikerdan 05-18-2009, 06:06 PM Have you called Edgeabout that? They have great customer support and I have seen several posts that had a failed probe, although it has never happened to me monsterD 05-18-2009, 07:08 PM Ive Been Emailing Them, They Are Super Chill And Helpful. I Was Just Asking The Board Cause I Know Theres Alot Of Knowledge Here Too | ||