I was wondering if 315's on hummer wheels rub in turning or on bumps (with snowplow) without a leveling kit? I was also wondering if they stick out beyond the fenders?

If they fit without a leveling kit could someone post the overall height from the ground to the top of their roof. I don't want to go through fitting the wheels on my truck and not being able to drive into the garage!

I may also put on hummer wheels with 285's. Any decision making suggestions on power loss (stock), ride, and towing?

I have seen hoot's pics from the side view, with a leveling kit I assume.:grd:

Thanks

PM Hoot, I think he has the same setup on his Dodge

HOOT: any help here? anyone else?

Don't know about the rubbing/ride questions, but you are aware that you need to machine out the center bore to make them fit? At least that is what I've been told, the center bore is just a hair too small.
Just a FYI in case you weren't aware.

Yes I am aware. I have read hoots install procedure and have a friend who is a machinist in a fully equipped shop. He said the machining should be quite easy.. Thanks for the heads up

Questions answered. Thanks Hoot.