machoosh
04-26-2005, 07:04 PM
Just got my new predator and at 6:00am this morning..on a quiet road,no traffic around I loaded 85 hp in. Did all the procedures properly unhooked the predator and started the engine. Placed it in drive and took off, not to hard but enough to try feel the new tune perform....then all of a sudden it was like it jumped out of gear ... seemed to stick in 2nd gear. So scared as hell i went to a approach and shut down the motor and reinstalled factory tune. Started her up and tried it....well it shifted perfect, except the light that looks like a motor stayed on.. what happened ? I hooked the predator up and erased the code ( tcm code ) but after erasing it still was there...till after i shut the motor off for about 20mins. then it went away.
So maybe I should have taken it easy and let the tranny learn ? tell whats up ?
Also I can't find the rev. limiter removal...it shows Max hp level or something...its set on 95hp and i can run it up to 125hp if i want..whats that all about ?
Looking forward to your answers
also i wanna know why it needs to know the tire width,height,and rim size when the axle option changes all the speedometer settings...
So maybe I should have taken it easy and let the tranny learn ? tell whats up ?
Also I can't find the rev. limiter removal...it shows Max hp level or something...its set on 95hp and i can run it up to 125hp if i want..whats that all about ?
Looking forward to your answers
also i wanna know why it needs to know the tire width,height,and rim size when the axle option changes all the speedometer settings...