Hey guys. How did you go about triming the corners of your trucks for bigger tires? What type of tools did you use? Also, how did you make sure that you didn't take to much off of one side. I might have to do it, so I don't want one side to look different from the other.
Thanks

William

Hey guys. How did you go about triming the corners of your trucks for bigger tires? What type of tools did you use? Also, how did you make sure that you didn't take to much off of one side. I might have to do it, so I don't want one side to look different from the other.
Thanks

William
Do you mean from the front airdam? If so, use a new blade in a razor knife, and just cut small (1/8") strips off at a time. You can use a piece of masking tape to "mark" the line you're cutting along. Go slow, take your time, and DO NOT put your hand behind where you're cutting!

Tom :eek:

Yeah, the front air damn. I couldn't think what it was called.

William

Dremel