I just got my Edge Insight with the pyrometer add on via UPS today :D



The instuctions for the pyrometer probe install are for a truck and it would be impossible to drill and tap where Edge recommends without manifold removal because the body of the van is in the way. It seems that a good spot for the install on a van would be at the date mark just foward and above from the Edge reccommended install location. I am a little nervous about this operation to be completley honest.


Anyone installed an egt probe on a van?

I installed mine on the drivers side manifold at the rear. There is a nice flat spot there for it.

Thanks Joey, I feel better doing the drivers..good excuse to get a BD if I dont get it right :)

Thanks Joey, I feel better doing the drivers..good excuse to get a BD if I dont get it right :)
Thats the same thing I said, to bad mine worked out and the stock one is still there.

Pyro probe is now installed and working well with thr Insight, Thanks for the help Joey!

I installed the probe bung on the driver's manifold, on the bottom at the rear in the spot where the heat sheild does not cover. Peice of cake.

I installed mine on the drivers side manifold at the rear. There is a nice flat spot there for it.
Thats where the local shop put the one on my truck too. I didnt want to goof it up, and they only charged me $25. I gave him the instructions that said pass side. Guess he thought the driver side was easier too.

did you get efi too?

did you get efi too?



I am still considering EFILive but I bought a Bullydog to hold me over.

Well, how is it working?

Well, how is it working?



It should be hopping on a UPS truck any minute...