Just got my leveling kit today and an in the process of going through the install instructions and getting all the parts install on the UCA.

Step 4 has you mount the bump stops to the bump stop tabs of the Cognito upper control arm. Were they part of the kit, or do I use the old ones?

Signed,
Confused

mine didn't come with bump stop tabs, still not sure about that.

mine didn't come with bump stop tabs, still not sure about that.

If you look at your pic you posted, your bump stop tab is there in the pic, leftside of the pic on the UCA. You have the bump stop bolted to it.

The Tabs are there - it is the bump stops that I was wondering about. Thanks for your responses . . . . . . .

I looked on the norcal website at the pic of the kit and it doesn't show them but they might be in a bag in the pic or covered up. Maybe some folks who also got the kit will chime in. Good luck!

I'm talking about the plastic bumps so its not metal to metal contact. They are in this picture.

yup, just a little plastic disc thing to stop metal on metal

OK - I'll go do a double check - might be in the bag of bolts -

Thanks again.

yup, just a little plastic disc thing to stop metal on metal

Yep, I just did mine yesterday, just as described above and they should be in the bag with all the other bolts and washers that came with the kit.

They must have missed it - I'll call them tomorrow and get em sent out.
Thanks.

They missed mine as well, wonder if they just forgot in this batch, who do I need to call?

Colorocko, I just talked to you right?

My wife said you called again and said you found them? Let me know so I can get them out to you.

Right - and I called back saying I found them - sorry for the confusion. That is what I get for working in two locations. - Unboxed everything - then moved to the basement.

I am set - and looking forward to getting it installed.

Thanks again for your quick response.

OK great!!

I just want to make sure you are set. I understand:)

Please post up after it's all done.