Last night I installed the edge juice attitude and it was an easy install (thanks to you guys) and it worked beautifull.
This morning, started truck, everything was normal.
Received one more "disclaimer" and pressed enter, everything OK.

Got to work (10min driving) shut the truck off, walked inside asked my brother
if he wanted to see it.
Started the truck and the display does not work. Backlight comes on (and the dim function works) but the screen stays completly blanc!!??

Can I do something or what can it be.
Try to start the truck a few more times, disconnected the attitude but same thing.

Any help is appreciated.

How did you run the attitude cable? Make sure if you ran it throught he door jam it isn't pinched or if you ran it through the firewall it didn't get damaged. Otherwise contact Edge. If there is no damage to the cable you will have to send it back to them for a replacement. On a rare occasion there are some bad attitudes (pun intended).http://www.dieselplace.com/forum/images/smilies/HiHi.gif

Also does the edge still give you power? It also possibly could be the edge module or even the connector on the edge module.

I ran the cable throuhg the rubber gromet in the fire wall.
Yes it still gave me the power en the screen came on (just a little) upside
down at first and then right side up but screen still looks completly messed up?

I think I will need to call Edge.
I just hope the will not make a problem of the little warranty sticker. I had to
losen that up to make it fit in the overhead.

I will give it a day.

Spoke to Edge (great service, like I heard before) and they will send me a new Atttitude!


Should work fine!!

Quite often the connection at the "green plug" :badidea: needs to be wiggled for better contact.

Quite often the connection at the "green plug" :badidea: needs to be wiggled for better contact.

John is correct. I have had a similar problem several times and was able to fix by playing with the cable connector between the attitude and the edge box.