dozerboy
03-05-2009, 10:11 PM
Ok I'm getting my V2 set up to log with and I saw mention of a. dtc file. I only have b, c, p, and u is that right?
|
dozerboy 03-06-2009, 03:22 PM I didn't see a.dtc on a screen shot of another user's so there doesn't seem to be one. I have the pmm files loaded, but can't find the PIDs. Do I have to select them first in the Scan tool? I was checking PIDs through laptop, but it wouldn't pull up the the trans PIDs the ECM would just come up again. I didn't have the AL6 pmm in the V2 yet if that matters. bballer182 03-06-2009, 09:00 PM b- body (bcm) c- chassis p- powertrain u- comunications (network) that's it no others dozerboy 03-07-2009, 12:10 AM Thanks dozerboy 03-07-2009, 03:17 PM Well I can log setting up my own PIDs is over my head until I do some more reading. bballer182 03-07-2009, 04:06 PM in the Options.txt file there are already some pre-defined pids that should get you started dozerboy 03-07-2009, 11:12 PM Ya I'm also using a options.ini file that Bio posted in the thread about checking trans strength. Do I need both, then I just had just the .ini it said I need a txt to select pids. If that is the case to add more pids to I put them in the txt file or a/the ini file? I want to log Actual rail PSI, but didn't see it in the pid description file. Can we not BBL it? dozerboy 03-07-2009, 11:24 PM Never mind I found FRP, but I'm still wondering about the ini and txt files questions. bballer182 03-08-2009, 12:37 AM yes an update or two ago was when that file got a work over and you need the options.txt file not the ini file now. the formatting of the options.* was completely revamped, however 99.9% of all of the pids remain the same so it you want to log the pids out of your old ini just copy and paste them to the txt file | ||