BigBlueBurban
02-27-2009, 04:06 PM
Are the upper ball joints installed incorrectly?
http://www.dieselplace.com/forum/garageimage.php?do=full&p=78098&d=1226467856
http://www.dieselplace.com/forum/garageimage.php?do=full&p=78098&d=1226467856
|
BigBlueBurban 02-28-2009, 03:54 PM Nobody? Swampfox 02-28-2009, 04:21 PM How much are your torsion bars cranked? I know if they are cranked all the way the balljoint needs to be bolted on the bottom. buildingup 02-28-2009, 04:22 PM If you have the bars cranked up they should be on the bottom of the arms. If they are not cranked its good. varty yo 02-28-2009, 04:23 PM yes i agree. i need to switch mine around. i never knew this either till it was pointed out by norcal jeff BigBlueBurban 02-28-2009, 04:25 PM Crap, they're cranked. drew1234567 02-28-2009, 04:44 PM Placing the UCA on top of the ball joint will add a little more room between the bump stop and frame stop. Nor-Cal Nick 03-02-2009, 02:04 PM Yes for leveling they need to be on the lower side of the control arm. MAX4X4 03-02-2009, 04:28 PM I like them on top......... Nor-Cal Nick 03-02-2009, 04:52 PM I like them on top......... Why are you confusing him.... We all know you like it on top;) MAX4X4 03-02-2009, 07:18 PM Why are you confusing him.... We all know you like it on top;) :nono::nono::nutkick::snipersmi Nor-Cal Nick 03-02-2009, 07:46 PM :nono::nono::nutkick::snipersmi Easy there vato ... don't blow a bag!!! :p: MAX4X4 03-02-2009, 08:31 PM Easy there vato ... don't blow a bag!!! :p: :angel: BigBlueBurban 03-03-2009, 02:08 PM So did Cognito include this little fact in their directions or is something left for the consumer to figure out? I didn't install them so I didn't look at those. Swampfox 03-03-2009, 02:43 PM It is in the instructions. Nor-Cal Nick 03-03-2009, 04:07 PM So did Cognito include this little fact in their directions or is something left for the consumer to figure out? I didn't install them so I didn't look at those. It is in the instructions. Yes they are...:( | ||