Ok I've seen SD manifolds, and now i have question about where to put the water/meth into the induction system. its pretty close to the motor,was wondering if put in closer the intercooler, could you get the cooling effects of the mix. its a tractor pulling thing. it seems from what i've read the dmax dosent like large amounts of wm, or maybe i'm reading more into it than that. Same thing with nitrous. I'm thinking about a SD manifold, but would like to hide the drugs down low in engine compartment. any advisewould be greatful. thanks MAXPWR!

I have something for that already that I tested more than a year ago. The problem is, the possibility of some water collecting in the down side of the tube and suddenly the engine gets a big drink when boost goes up. I do have controllers that use the RPMs and EGT, and water solenoids to controle the mist for those who want to spend a fortune getting to the same place as the simpler system does (same cooling, and power). I can make one for you, but you would be on your own in the testing department.

I had kinda the same ideas, but wanted some feed back. Most tractor I've seen don't use intercoolers. Is this the same with nitrous? And if so, on either one after the intercooler,but futher back from the intake give a little time for the WM to atomis? Just asking. Will be adding more toys this summer.

The N2O does just fine down below post I/C but the water is best atomized right at the intake track. You don't want to give it time to turn back to just water droplets again. It has to go through alot of curves already where it is mounted. Idealy, one small nozzle should be mounted at each intake port for best results. I will be doing this very soon with a spare set of intake manifolds I have. Alot of work to get them changed though. Not all that much worth the effort unless you make it a dedicated puller or some thing and are out of warrantee any way.

If I'm trying to over think this. Let me know. just some different ideas I had been looking at these motors. I've seen a thread about a web address with your products, havn't seen a real address yet.

I have a NOS system, I'm about to put on. any thing I should change with this kit? what jet size to start with?