I know this pump uses some special o-ring based fittings. I want to hookup via 1/2" fuel line using a push-on barbed fitting. Does anyone have a part number of a known fitting that works? I know all about JK's fittings but want to install in the next few days and want to be able to use 1/2 fuel line. I'm also looking for the part number of the bracket that holds these pumps so I can make my own baseplate/mount. Lastly, anyone have a part number (NAPA, GM, etc.) for an oil pressure switch that will ground when pressurized? I know I need a 3/8" NPT to 1/4" FNPT adapter to mount OPS in oil filter mount assembly?

tophog...........after much digging through my pile of NAPA receipts, I believe I have some part numbers.

The OPS I used is #701-1575......I believe I ran a seperate ground wire as it is a 2 pole switch.

Fuel lines are standard GM repair parts from NAPA. I used #730-4940.......I think it's a short one, and #730-4933......this one is about 12" long. Hope this helps.........