Last night my wipers were froze down. Occasionally I would try to get them to move. I could tell they were trying to go but I figured eventually they would thaw out. Now all I have is high speed. If I don't shut them off at the bottom they stop anywhere. I searched on here and found a few reports of wipers that won't stop at all, but not this scenario. I also still have washer.
Do you guys think it's the module needing to be resoldered? Or do you think it's a fried module , or ????? Thanks

Its likely the board, I have replaced them in older trucks, but not sure if you can do that in the newer trucks.

not sure if these have a board like the C/K trucks did. Probably did fry it though.

I asked the dealer about the cost of a module today $112... ouch.

It was the board. Bought used unit $30 shipped. Only used the module since it looked like a pain in the ass to change whole thing. Now I have a good used motor&gearbox leftover.

good deal, good to know.

what was the part # of the board???

or where did you get one for $30, mine is doing the same thing

i could possibly resolder mine if it is bad connections.

where is the module located on the truck so i can check it out,

thanks