|
squeeky 01-19-2009, 12:40 PM Well just a little while ago I was driving and tranny done all sorts of noise and then check eng light. Got home no reverse. Ran the codes only got a P0700 code. P0700 (Trans Control System Malfunction) Ok so what does this actually mean? squeeky 01-19-2009, 04:35 PM Ok so I went to Autozone and got the codes read there too. I got the P0700 and P0735-incorrect Gear 5 Ratio. So how can I fix this? I had them reset the codes. The CEL is off now. Guess I will see what happens when I go to work. BoostEEd 01-19-2009, 07:45 PM P0735 would indicate you slipped a clutch. Take a look at the fluid and see what color it is and if it is burnt. allisondan 01-19-2009, 07:52 PM Its it a grinding noise only in certain gears,or all the time ?? squeeky 01-19-2009, 08:17 PM P0735 would indicate you slipped a clutch. Take a look at the fluid and see what color it is and if it is burnt. Hadnt checked it yet. No grinding that I could hear. Guess that it just went into limp mode. See tomorrow how it does. dansdieselp 01-19-2009, 08:20 PM Was it cold when it did this? squeeky 01-19-2009, 08:25 PM Around 38*. MMLMM 01-19-2009, 08:42 PM 0700, will put it in limp mode. Tony Burkhard 01-19-2009, 08:47 PM sounds like you gave the trans more than it could take.:D After you cycled the key did it drive normal? squeeky 01-20-2009, 05:13 AM sounds like you gave the trans more than it could take.:D After you cycled the key did it drive normal? I reckon that I did give it more than it could take. Yes after I cycled it before I went to autozone to clear the codes it drove normal. jerkyboy 01-29-2009, 05:39 PM what's the latest with the tranny?? | ||