This afternoon I set off the following codes: P0101, P0103, P0401, P0404, P1404. I'm wondering if my fingers stick has maybe gone bad or something? Truck runs fine, but the codes come right back as soon as I clear them then restart the truck. Any help would be great.:mad:

Dug a little deeper and it appears that the stick had water under the heat shrink. Will this thing work again you think when it dries out?

As long as the IC chip didn't short out, it should dry out and work fine.

I try to seal them as best I can, but they are not waterproof. What mud bog did you go through to flood the Stick?

i think i might dob a little silicone on the ends of my stick :rolleyes: .

It was called washing the engine bay, obviously not to carefully

How did you get the codes out of your truck? Is there a way to do it on the LCD display on the dash below the gauges?

Thanks!

You have to use an OBDII code reader.

The codes will clear themselves after the cause of the problem goes away. They will clear from memory after 40 ignition cycles. IIRC