gandgracing
12-20-2008, 07:40 PM
Steering started acting funny so I jacked the front end off the ground and found the passenger wheel hub bearing were shot. Bought new hub and installed. Started off down the driveway and everything was good until I hit some ice and the ABS kicked in. So now I have the ABS light on but brakes are still working like normal. The problem is when the ABS light goes out. If I'm going down the road and slow up for a light and then start to take off the light will go out but if I try to use the brakes while the light is out it will pull extremely hard to the left and make a grinding sound. Took off all front brakes and everything is ok there. Whats the deal? I also put a voltmeter on the wheel sensors while spinning and they are both registering.