I have had my AirDog 150 and my Titan tank installed for a little bit and I have been thinking. My AirDog is too close for comfort next to my Titan Tank. See the pictures. I had to put some metal plating glued to the tank to prevent the AirDog body from rubbing a hole into my tank.

My tank does slide forward at times. I am waiting for a new saddle bracket for the front and new updated brackets for the rear.

Has anyone else had this problem?

By the way - How does the fuel cooler supposed to work if airflow is blocked by the tank???

FYI - I am removing the torsion bars from the truck and the cross bar permanently as soon as my Fabtech coil over lift goes on. Meaning The pump slides forward a bit.

http://www.dieselplace.com/forum/garageimage.php?do=full&p=80548&d=1229397209

http://www.dieselplace.com/forum/garageimage.php?do=full&p=80549&d=1229397257

http://www.dieselplace.com/forum/garageimage.php?do=full&p=80550&d=1229397281

I would deffiently relocate it to a diffrent spot.

It will be moved forward once the lift goes on. I was just curious who else has this setup and the similar situation.

My AirDog is too close for comfort next to my Titan Tank. See the pictures.

http://www.dieselplace.com/forum/garageimage.php?do=full&p=80550&d=1229397281
I think I am missing something. I don't see any pictures.

2x I think I am missing something. I don't see any pictures.

On my extended cab there wasn't any convenient mounting place under the truck. It wound up just forward of the rear wheel. Picture in my garage. The factory AIRDOG mounting bracket works when modified. Then make a brace just to be safe.