Thanks Kroutman and Fingers, I received both products and installed both within a hour. Just to let the leary know I am an electronic tech and one of the three stooges when it comes to mechanicing, but this was easy. I soldered all of the connections on the finger stick, I only cut one wire and just stripped the insulation back on the others. I used rubber insulating tape and then electrical tape to seal up. On the blocker plate I planned on getting this installed by my mechanic but I just gave a half a** effort and found it very easy to install. I will report driving results after a few miles. My new home is this forum, Thanks all.

Glad to hear it went smoothly.

Same Here. Glade you liked the Plate.:thankyou2