PPE lift pump installed but [Archive] - Diesel Place : Chevrolet and GMC Diesel Truck Forums

: PPE lift pump installed but


c55asleep
11-25-2008, 12:06 AM
Well, I got the lift pump in with all the wiring and tube routing and it works great. The only problem is that where i am getting my ignition power for it is from aux. hvac. At first i thought it was an aux. a/c system and did not need it but then i did some searching here on the forums and found that it aslo has to due with the compass, dash lights and (mil). When i reinstalled the fuse i got two codes (381) & (650) same codes that i found in my searching. I erased them with my programmer and all ok. My question is where is everyone putting there wire for ignition at under the hood. I checked every fuse and some etheir have constant power or nothing. I am running it back on there with a fuse but would like to find another location for it. Thanks Roly

AlligatorPerformance
11-25-2008, 12:10 AM
Is there an aux fuse in the fuse box under the hood? That is where we always hook up to on the LMM's.

c55asleep
11-25-2008, 12:18 AM
Is there an aux fuse in the fuse box under the hood? That is where we always hook up to on the LMM's.

Chad i checked one by one but with no luck. Maybe i am not checking correctly or something?? I checked fuse by fuse under the hood. Where is the one you are refering to? Thanks

AlligatorPerformance
11-25-2008, 01:39 AM
It's on the right side, 3rd or 4th row over and about 4 or 5 up from the bottom if I recall correctly.

c55asleep
11-25-2008, 02:38 AM
It's on the right side, 3rd or 4th row over and about 4 or 5 up from the bottom if I recall correctly.


Thanks Chad, I will try again tomorrow see if I can find it.