ShumDit
12-08-2003, 11:35 PM
Need to remove the oem drinkholders on my 40-20-40 bench seated 02. They're the ones that are virtually on the tranny hump. Unable to figure/see how to remove them. Has anyone done so? If so, how?
TIA
TIA
|
CADman_ks 12-09-2003, 01:02 AM I don't know how to get them off, but they are kind in a dumb place aren't they... cadman_ks ShumDit 12-09-2003, 01:32 AM Sure are ~ really awkward for us and I did install a dash mounted drop down from a suburban like 56chevynomad did. Now I need more tranny humpspace for my CB mount w/enclosed speaker. Gr-r-r-r, perhaps a chainsaw can take care of ithttp://www.dieselplace.com/forum/smileys/Evil Smile.gifEdited by: ShumDit Mackin 12-09-2003, 08:15 AM Helms manual says in open position "Remove the tabs that connect the cupholder to the floor console by gently prying apart with a flat bladed tool " .... Tabs are located near inside center of cupholder in the PIC .... Reassembly: "Install the cupholder to the floor console by snapping tabs to console back piece ".... Mac http://www.dieselplace.com/forum/smileys/Approve.gif ShumDit 12-09-2003, 12:00 PM Mac ~ Much thanks ! http://www.dieselplace.com/forum/smileys/Big Smile.gif Go'in tab huntin' http://www.dieselplace.com/forum/smileys/Ermm.gif | ||