Any guys running the attititude wiring through the firewall for the E/J? I have the Trippin overhead mount. I ran the wire through the headliner, down the pillar, out the door then through the hood latch. Every time I open and close my door it gets pinched a bit.:o: Has anyone ran this wire through the firewall, if so where, and doubly if so do you have any pictures? JJ :)

i ran mine through the firewall JJ. Here's some pics for the install that I used.I pulled the rubber seal out to thread the wire through. Hope this helps
http://community.webshots.com/user/gtripp41

I just poked a hole in the main rubber gromet and fed the wire through it. Its right there where the Edge mounts under the hood. its good to keep it away from any moving parts.

I used the hood release grommet. I pulled the grommet out, ran the wire thru and pushed the grommet back in, about 3/4 of the way. Again, any trips to the dealer, pull the attitude wire out and push the Grommet back in all the way. No different holes in the firewall or Unnecessary cuts in the main one.<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" /><o:p></o:p>

ran mine were the snow plow goes, I had to drill the hole
http://www.dieselplace.com/forum/attachment.php?attachmentid=2308

Thanks so much for the intel guys. :ro) I'll explore these options. Later. JJ :)

Check out "Mod pics" in my sig for throught the firewall.