Is my six gun recognizing my speedloader if the green LED on it is flashing once when the key is turned on? It sais in the instructions it will flash twice, but mine is only flashing once. Any suggestions?

If you have it hooked up right, you need to have the system recognise it. Put the switch to 1, turn to 6 then back to one with the truck turned to run w/ the key. The 6gun should do some blink twice. Turn the truck off, turn it back on and it should blink twice then remain steady.

I might be wrong though.

Technical & Installation Support: 888.839.2700
Non-technical Customer Support: 888.839.5600
Mon-Fri 7-5 (PST)

there's the number.

You're correct, you have to go through the 1-6-1 sequence for the 6G to see the SL. This is spelled out in the install/user guide. Tech support can verify, too!