I am finally getting around to finishing up some projects. Here is how I did my switch panel.

I decided to remove the overhead compartment completely. You can see the right two studs have been drilled out.
http://i105.photobucket.com/albums/m202/ads47/DSC00063.jpg


Switch Panel wired and ready. One switch was wired separate.
http://i105.photobucket.com/albums/m202/ads47/DSC00064.jpg

Harness Complete
http://i105.photobucket.com/albums/m202/ads47/DSC00065.jpg


Ready for re installation.
http://i105.photobucket.com/albums/m202/ads47/DSC00067.jpg

Back in the truck.

http://i105.photobucket.com/albums/m202/ads47/DSC00068.jpg

Pass through complete, grommet in, and painted. (the paint didn't run its just the way it looks)
http://i105.photobucket.com/albums/m202/ads47/DSC00073.jpg

Shallow hole saw used.
http://i105.photobucket.com/albums/m202/ads47/DSC00071.jpg

Nice install:thumb:

Damn that's a clean install, nice job!

Thanks, so far so good a few more projects and I will be done with it.

ads

what did you use for the base mounting plate for the switches; awesome install, very clean and neat

Its a SoCal Switch Panel from Guy.


ads

Clean i like it.

looks good reminds me that i need to rewire my stuff and make it much neater

thanks