Im Trying To Install A Remote Starter On My Work Truck Its Not My Pick Up Its An O7 Chevy Van Gasser I Use For Everyday Work Does Any Body No What The Color Of Wires I Need Are Its Just A Cheapy R-start Ungo From Clarion With Dei Passlock Module Install Is As Follow
Purple Goes To Starter Side
Green Keyside
Orange Output Accesory To Run Heat And Ac
Then I Need To Find And Cut Ignition Wire
Yellow R-code = To Ignition
Blk/yellow Bcm =away Ignition

CHEVROLET

MODEL YEAR(S)
EXPRESS VAN 2003 -2007


PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED/BLACK (+) IGNITION SWITCH HARNESS
STARTER YELLOW (+) IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 PINK (+) IGNITION SWITCH HARNESS
IGNITION 2 WHITE (+) See NOTE *4 IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE LIGHT GREEN (-) IGNITION SWITCH HARNESS
PARKING LIGHTS ( - ) BROWN/WHITE (-) @ BCM, BROWN Plug, Pin B2, See NOTE *1
PARKING LIGHTS ( + ) BROWN (+) @ FUSEBOX UNDER DRIVERS SEAT
POWER LOCK LIGHT BLUE (TYPE B) @ BCM LIGHT BLUE plug, Pin B5, See NOTE *1
POWER UNLOCK WHITE (TYPE B) @ BCM, LIGHT BLUE plug, Pin B10, See NOTE *1

DOOR TRIGGER See NOTE *2 @ BCM, LIGHT BLUE plug, See NOTE *1
DOMELIGHT SUPERVISION GRAY/BLACK (+) or DARK BLUE/WHITE (+) @ BCM, BLACK Plug, Pin E, See NOTE *1
HORN TAN (-) @ BCM, GRAY Plug, Pin B9, See NOTE *1
TACH WHITE or PURPLE @ PCM, GREEN plug, Pin 26, See NOTE *3

BRAKE WHITE (+) @ SWITCH ABOVE BRAKE PEDAL

ANTI-THEFT YELLOW (+) and BLACK (-) or TAN (-) GM's PASSLOCK 2 System, these wires exit the Ignition Switch
NOTES
NOTE *1 The BCM (Body Control Module) is located under the PASSENGER side of the dash, behind the knee bolster.


NOTE *2 This vehicle has 3 door triggers, the DRIVERS DOOR is a TAN (-) Pin B4, the PASSENGER DOOR ad REAR CARGO DOOR is a LIGHT GREEN (-) and the REAR DOORS and SLIDING DOOR is a YELLOW/BLACK (-) in Pin A10. When connecting to an ALARM SYSTEM, use all 3 and DIODE ISOLATE. See DIAGRAM


NOTE *3 The PCM (Power Control Module) is located on the DRIVERS SIDE FENDER. On the 4.3L engine the TACH wire is WHITE, and on the 4.8L, 5.3L and 6.0L the TACH wire is PURPLE.


NOTE *4 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!!
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2

EXTRA INFORMATION

Awesome Thank You Very Much