For those of us that tried to use the bracket furnished with the Edge Attitude, there is something better coming.

I never even got far enough to install the bracket, when the set screws didn't work. Edge sent me a new bracket.

That bracket still wasn't worth installing.

So, I used velcro and installed it on the front edge of the dash by the 4x4 switches.

The following is the response from edge on making a better bracket.

"We are in the process of redesigning the mounting brackets and appreciate your feedback. We hope to have a new design out for it very soon. We appreciate your patients in the bad design of the old bracket and as soon as we have a new one it will work a lot better. If you have any other questions or concerns then just let us know.

Thanks"

Hope is in the wind.

:cool2: :grd: :cool2: :grd:

thats how I did mine
http://www.dieselplace.com/forum/attachment.php?attachmentid=2309

Looks like you copied me.
:lol: :lol: :lol: :lol:

heres how i have mine mounted
http://www.streetracr67.photosite.com/Album2/

gearhead,

I see in your pic you replaced the factory 4wd switches or is that the way they were done on '03's? I think the ones I have suck. Sorry to go off topic here.

Here is mine. Just snaps over the Stock Pillar. Again, no signs of mounting.
http://dieselplace.com/forum/attachment.php?attachmentid=2211&stc=1

gearhead,

I see in your pic you replaced the factory 4wd switches or is that the way they were done on '03's? I think the ones I have suck. Sorry to go off topic here.
I have the floor shifter so there was a stupid compartment there. the three switches are my high idle,aux back-up,and inside bed lights.

I have the floor shifter so there was a stupid compartment there. the three switches are my high idle,aux back-up,and inside bed lights.
http://www.dieselplace.com/forum/images/smilies/cool2.gif