I Am Wondering If Anyone ( Especially Fingers ) Has Figured A Way To Make The Fingers Stick, Plug In And Run, I Just Can Not Bring Myself To Cut A New Wire Harness. I Know That This Would Be Much More Expensive But The Peace Of Mind Knowing I Have Not Damaged A Perfectly Good Harness Would Be Worth The Extra Money,plus The Ability To Remove It With No Sign That Anything Was Modified. With Other Changes You Can Always Put The Stock Part Back On,you Cannot Undo A Splice Into The Harness. Thanks To All For Any Replys

I did the research a while ago with the help of some forum members. Not all the needed connectors are available for starters. Add to that the manufacturer's minimum orders for what is available, and it was too much financial risk for me. IF I could sell the 500 units to cover the minimum order, the cost per stick would jump well over $50

In short, it is not worth it to me.

I did the research a while ago with the help of some forum members. Not all the needed connectors are available for starters. Add to that the manufacturer's minimum orders for what is available, and it was too much financial risk for me. IF I could sell the 500 units to cover the minimum order, the cost per stick would jump well over $50

In short, it is not worth it to me.
Do you have a link to where we could get these connectors? I'd be willing to spend $100 for a fingerstick that requires no cutting.

Fingers; Thankyou For Your Response On This Post,i Still Feel As Wasted Income Does That Whatever The Cost, It's Better Than Splicing Into The Harness. Thankyou For Passing On Knowledge,i Find Your Posts Very Informative

Do you have a link to where we could get these connectors? I'd be willing to spend $100 for a fingerstick that requires no cutting.
They are Sumitomo connectors, min order is about $3500

Do you know exactly what you need?

I had really good luck with Power and Signal group getting high idle pins when nobody else had them or could get them. They normally don't sell smaller orders, but they worked with me on the pins. Is it worth a shot?

Just FYI, these guys don't seem to like small orders. Seems minimum orders just aren't worth their while, at least that's the way they act. I never did get the samples. How 'bout you Fingers?

Do you know exactly what you need?

I had really good luck with Power and Signal group getting high idle pins when nobody else had them or could get them. They normally don't sell smaller orders, but they worked with me on the pins. Is it worth a shot?
Thanks for the lead, But I can get the connectors. I can't justify the investment. TOTAL production to date is only 260 units. Min order would be for 500 units. Too much risk/hassle for too little gain. There are other reasons, but the money is the biggest.

Here is the bottom line. I am not interested in doing it. If someone else wants to add the connectors, drop me a PM and I'll set you up.