Just got this Pro Stock Component machine out after almost 2 years of planning and work ran 1 good time out of 4 so far having some head and water inj issues

looks good, if you need a driver I'd be happy to play with it.

what motor, 466 or something bigger?

Its was a 466 lol now its pushing 680 cubes 2500 hp

Will it be at the National Championships at Bowling Green, Oh this weekend? Saw lots of them go by yesterday on the way there.

Nice to see a red pro-stock. My buddy owns REI and they build the 680 cube john deere motors for all the big guys. My son worked there for awhile.

Its was a 466 lol now its pushing 680 cubes 2500 hp

I didn't have any idea what they run in the classes now. dad had a 327 and glide in his F-20 back in 1970.

Not to be nosey or anything, but how much money do you guys have in motors like that?

Its not too hard to spend the money got around 16,000 in to just the head alone wont be going to BG Ohio too far away from home. Besides were still making break in runs and trying to get weight figured out as to where it should go. Not sat down and figured up total cost of build yet but should be 60,000 in engine with labor. Not an REI engine not very impressed with what they have done thats red they are tops for BBJDs. Its a Engler Chassis, Pro Fab Rear end

What size turbos does a pro stocker run?

Not sat down and figured up total cost of build yet but should be 60,000 in engine with labor.
Thanks. Good luck and hope she runs sweet:D

That should make just enough power to run our round baler! Mind if I borrow it this fall to put up some rounds? :D

That is one pretty red puller! Good luck and great job!

What size turbos does a pro stocker run?
4.16" to 4.6" Cast or Billet with 4.4" Exhaust Holset 32 or 36 Exhaust housing

Nice looking tractor , best of luck.