I finally recieved my LED tailights for Trucknvans,(waited 4 months). you can see them here: http://www.trucknvans.com/EuroStar_LED_Taillamps_99_05_Silverado_Sierra_p/led648.htm

You will need to modify the tailight bucket somewhat to make it fit, you can see where I made the cuts below. They are nicely made with some sort of ballast-the reason you need to cut the bucket. The lights are brighter than stock and of course they look cool. The bottom lights up a lot like the angle eyes on headlamps. Not cheap at $300 a pair.

Look's good.

Does the whole light brighten up when your step on the brake's or only the upper or lower half? How about with turn signal's?

Looks good.

Ben

Sweet:ro)
How bright is the backup light? I'm assuming they are led's also.
But I not a clear guy.
These I just might do...They hide the led's better.
http://www.trucknvans.com/EuroStar_LED_Taillamps_99_05_Silverado_Sierra_p/led650r.htm

Besides the cutting, was this a 'plug and go' install, or did you have to mess around with your wiring also? How is side vis?

These look cooooool

That is a wild looking set up. Looks great. Nice pics too.
Not really a bad price for a pair of LED lights and lenses if you compare them to the APC style lenses.

Other than the cutting, it was a "plug and go" install. All the cutting is just plastic so it''s easy to do. I called the distributer and told them that cutting is required and there is now a notation in the taillight discription that it is required. They also raised the price! (It was $280). You can see in the backside picture the two short pigtails that plug into the existing bulb sockets. You do use the standard back-up bulb, (it's not an LED).