|
: P0106 Manifold Abs. Pressure Diesel Power 12-03-2003, 12:22 AM Eric, ever seen this code before? Comes on over and over after a bit of time in my buddy 02 CA D/A. Thanks Nick modified 12-03-2003, 09:32 PM Per Helms 2002, P0106 sets when "The difference between the BARO sensor and the boost sensor is more than 20kPa for two seconds". Here's a couple of guesses. Got gauze type air filter, such as K&N? I see "Actuator" below your name. Is this a Banks Big Head? What boost pressure are you running? Diesel Power 12-03-2003, 09:38 PM Actually its on my buddy's truck, not mine. i already looked it up in the help manual. unfortunately troubleshooting requires that i read the baro value, which my preadtor can't do http://www.dieselplace.com/forum/smileys/Disapprove.gif He has stock truck. he runs an amsoil air filter.. i already thought he might have over-oiled it but we haven't had time to check. I do have a banks actuator, yes. i have it set to about 28 PSI max.. dmaxalliTech 12-04-2003, 09:56 PM Nick, start by cleaning the MAF, I know that isnt what the code is, but i have seen it before... Diesel Power 12-05-2003, 03:40 AM what is the best way to clean it? don't want to mess up my buddes MAF! dmaxalliTech 12-07-2003, 09:19 AM CRC 'lectra clean works good, leaves no film. I was looking through my notes and I did have a couple of these early on that I replaced the boost sensor on and it took care of it. | ||