OK, now that I have reset my engine oil life about a dozen times, how do I know if the Banks is reset? I am supposed to get a green flashing light when it is performed correctly. I get a red and green light and then an alarm. I also found out if you do this enough that the cycling of the pump without start up will cause a check engine light with codes related to fuel pressure at the rail. I am also getting a fatal error when I go to change the guage set up on the pda (should I re-install the banks software on the pda?). I also noticed that when the pda reboots it recalls self diagnostic information that has previously cleared. I have not had the time to go out and educate the tranny yet and cycle through the gears 15 times in each level.

OK, now that I have reset my engine oil life about a dozen times, how do I know if the Banks is reset? I am supposed to get a green flashing light when it is performed correctly. I get a red and green light and then an alarm. I also found out if you do this enough that the cycling of the pump without start up will cause a check engine light with codes related to fuel pressure at the rail. I am also getting a fatal error when I go to change the guage set up on the pda (should I re-install the banks software on the pda?). I also noticed that when the pda reboots it recalls self diagnostic information that has previously cleared. I have not had the time to go out and educate the tranny yet and cycle through the gears 15 times in each level.


Tell me about the cycle gear thing?

According to the manual, after initial install you are supposed to cycle through all gears 15 to 30 times in each power level (getting on it hard a few times each level). Basicly going from a stop to 65 mph 15 to 30 times.

Moved to 3rd Gen ELECTRONICS Section! ;)

How long have you had the banks with pda?

Which software version are you running???

I have had it installed for about 2 weeks. Software is 1.9 according to the PDA.

I have had it installed for about 2 weeks. Software is 1.9 according to the PDA.



I never know version 1.9 came out. Try to run the 2.0 verision & see if that is better. You can download that off of the Banks website.