Yea it was the best way for me to explain it. Guys is this problem serious I took these pics the leak is on the drivers side there was a little oil on the ground after I put her into 4-low. Driver side wet as seen in pics, and thicker on the metal obviously where it has been collecting. Repair tips etc would be greatly appreciated...

Look up over the output shaft , I do not believe it should leak at the flange .

I'd say the seal behind it is leaking, kind of see it in the middle pic. oil is then thrown out when it turns.

I've not had one apart put if the flange bolts on like a drive shaft yoke, it needs some sealer put on the splines to keep oil from wicking along the splines.

I'd say the seal behind it is leaking, kind of see it in the middle pic. oil is then thrown out when it turns.

x2

Thanks guys... I'll tear into it next week.

Would it be best to keep the drivers side up on the ramp to let the fluid drain to the passenger side?:rolleyes:

Thanks guys... I'll tear into it next week.

Would it be best to keep the drivers side up on the ramp to let the fluid drain to the passenger side?:rolleyes:

how long since it's been changed?

I'd drain and refill.

I will do that.. Not sure, I haven't done it and it has 50K on her. Thanks again. You still got the short bus? Tim...