Installing exhaust and ran into major problem,hanger clamp for extension pipe is not correct.Instructions say to use shortest hanger clamp which is not even close to working,also tryed the next longer one which will not work either.The longest one works at rear of muffler tailpipe connection.Kind of totally disgusted with this setup,way too sloppy of joints at muffler,have not tryed tightening any clamps yet and ready to ship back to Nate at PTP.Any suggestions.

Well I made the longer clamp-hanger work on the extension pipe and the joints did tighten down with no leaks,guess all is well there.Now one reason I purchased this system was to decrease EGT,made a test run before and after install to compare EGT,run included a flat stretch with a mile of 6% grade to finish it off,saw no difference in EGT.Also the noise level is a tad more at idle but the same going down the road.Now all I can hope for is better fuel mileage,aint gonna hold my breath there.Oh well the price tag was only $288.