Well the gauges are installed and I went again with the ISSPRO.

They have just the basic lamps and as you all know it leaves a yellow ting. I want to get the white look and I am thinking LEDs will do the trick.

I went to AutoMeter and it looks like they only sell the colored LEDs and on top of that it looks like they do not have what I need.

Anyone out there change over their ISSPRO lamps with LEDs? If so how did you go about it?

Thanks for your help.

lamp PNs: 158 3 3 and KD 45C (do not know if this helps?)

I believe you can buy bulb covers through isspro which will make them look white. I have the covers on mine and they match my guage cluster perfect.

I believe you can buy bulb covers through isspro which will make them look white. I have the covers on mine and they match my guage cluster perfect.

Really! That would also work.

Do you have any part numbers by chance?

http://www.isspro.com/proddetail.php?prod=R7772

Is this the color bulb cover you went with?

I do not see anything that would make the light white. I am guessing this blue cover will make it closer?

Those would be the ones.....I'm not for sure which guages you have but the pyro bulb is smaller. Both of the covers should be listed. I will try to get a pic for you later on tonight.

smkndmax5 thanks for the help!

I noticed the pyro and oil temp lights are small. I will give ISSPRO a call the morning. This fix will be a lot cheaper than replacing all the lights with LEDs.

ISSPRO sells LED replacement "bulbs" in white as well as colors. I'm not sure if the bulb covers will give you the color you want, but they're cheap enough to try it out.

Regards,
Michael Pliska