Does anybody know if the Attitude EGT sender will work with the Isspro or the Autometer EGT gauge??

Rick,

Looks like you can:

Here is a post discussing this with the Autometer gauge:

http://dieselplace.com/forum/showthread.php?t=19944&page=1&pp=10&highlight=autometer+probe

Here is a post discussing the Autometer and Isspro:

http://dieselplace.com/forum/showthread.php?t=20218&page=1&pp=10&highlight=autometer+probe

After being asked this 3-5 times a week, looks like I'll need some form of a canned reply.

I say 1 gauge to 1 probe. That said, it appears that the new gen electronic gauges aren't altering the signal much if at all. Before I'd do it, I'd set up a controlled temp, and test with one, and then 2 "loads" to verify that the readings remain steady...

Thanks for the response guys. I searched the site, but did not see the threads you listed. JK I had also e-mailed you directly so no need to respond again.

All of the different probes, J, K, ..... are "standard" in that they have a calibrated mV/degree response. So if a guage is calibrated for "K" style probes, it should work with any "K" probe. The connectors on the end of the probe lead is another matter......

Rick, are you looking at one gauge, or tying 2 to one thermocouple?

Just one.