How do I make my #2 remote = the #1 driver in the DIC? My #1 remote no longer works, but my #2 remote changes all of my settings.
:help:

You will need to reprogram it as the first remote.

Transmitter Programming



Important

Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.



There are 3 methods for programming transmitters, which are listed below as methods 1-3. Up to 4 transmitters may be programmed to the passenger door module (PDM). Each programmed transmitter is given a position of #1-#4 in the PDM memory.

Method 1 - No Tools Required, Program All Transmitters



Important

All transmitters which are to be recognized by the PDM must be programmed in a single programming sequence. When using this program method, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter.

The order in which the transmitters are programmed will determine its numbering position within the PDM memory. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. The number stamped on the transmitter case is for reference only; #2 can be programmed as #1, or vice versa. Additional unnumbered transmitters are also available.



<LI type=1>Close all the vehicle doors. <LI type=1>Insert the ignition key into the ignition lock cylinder. <LI type=1>Press and hold the door unlock switch. <LI type=1>While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. <LI type=1>Release the door unlock switch. The doors will lock and unlock to confirm the program mode. <LI type=1>Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter. <LI type=1>Repeat the previous step to program up to 4 transmitters. <LI type=1>Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.
Operate the transmitter functions in order to verify correct system operation.

Program the 1 & 2 button on the door the same. If you are the primarry driver, then you don't have anything to worry about.

Thanks a bunch guys