okay to start off with i installed the air dog 150 friday everything seemed to go alright approx 4 hours for install.got it all together put fuel in the air seperator.started the truck perfect checked for leaks no leaks all done right.now this is were its 6 at night my work closed im taking my truck out of my hoist area running fine them it stalls dead.i figured low fuel so i put 5 gallons in it nope not it.tried using the primer on the stock fuel filter got air bubbles.refilled the fuel filter and air sep on the air dog.turned pump on got straight fuel running out of stock filter great.soon as i try starting it it gets air in the fuel.not sure what it is yet now its 730 pm work closed at 6 i had to leave now i wont get to it until monday.i hate not having my truck:mad:.i will see what it is monday and post it.

Wire the fass pump to a switch and run it till you see clear fluid out of the bleeder port. CLOSE bleeder port and pump the primer till hard this should push any slug of air through between stock filter and CP3.

If you don't get fuel at the bleeder port with the fass on then you might have it plumbed incorrectly. Also if you didn't know you cannot start/run the truck with the bleeder port open. It's not like the old 6.5 diesels.

I don't care for any lift pump setup that doesn't have a prime over ride switch installed. My buddy in his Dodge has a Fass and he changed the filters, didn't re-fill put them in dry. He ran his batteries dead priming.

I had to give him a jump and I HAD to prime it for him,he was lost. :D

i did fill both filters and ran the pump until straight fuel out of my stock bleeder tighten the bleeder screw try to start vehicle it wont.look at fuel at bleeder again all aired up and the filters at the air dog are empty just a little on the bottom?sounds to me the line tank to pump may be letting in air or pump is bad?i have to finish a couple of jobs before i start on it.dam it

okay on a somewhat good note im getting a new airdog sent to me and we will see what happens.fleetgaurd changed filter designs without airdog knowing that causes the filter to bottom out on the pump before the seal makes good contact creating a air leak.they are correcting the problem already.so we will see if the new one works and i will post it.also they are coming out with updated quick connect fittings also mine did not fit also:(.and i made a suggestion to them they need to include a plug for the fuel line left open when you install there pick up in the tank they made a note of it.trucks been down seince friday and im in a rental:mad:.hopfully the new pump comes in tommorrow and its all better:).
fred

Fred, how did things go? Did you get everything installed?

okay i got the new pump wed.i installed it bled the air from the stock filter truck fired right up i dont know exactly what was going on with the pump but they(air dog)made good of it.only thing still disappointing is they dont give you the correct quik connect fittings for the fuel line.mark told me they had them i thought he would send me one but did not:(.so i cut mine a 1/8 inch and i t fit great just need to make sure the sharp edges are gone or it will cut the seal:cool:.other than that i think its a great product there cust service is great.the kit just needs some little adjustments and it would be alot better install.had my low fuel light on and it ran great i thought it might starve for fuel that low it did not.
now i will see if the mpg gets better.
fred