How in the ***** do you remove the blower motor? (96 C2500 Suburban) Ive taken every bolt and nut loose on that steel pipe that runs from door to door across the bottom of the dash and it simply will not budge. Its as if it was welded down. You simply cannot replace the blower motor until that is removed. I even fought to remove the ECM only to find a big black plastic bracket beneath it that you cant remove either. At this point it looks like you have to rip the whole dash from the truck just to replace a silly little blower motor. The holdup is that ******* little cover over the motor. you cant take it off until that pipe is gone. What do i have to do to get it out of there? It will wiggle around on the end but in the middle its stuck. I can see a weld mark where it was welded to a bracket and that seems to be where its held at. i removed two bolts from the bracket and its STILL stuck. I cant even drive this thing anymore until this is fixed. The ecm is out of it and the bottom of the dash is laying in 10,000,000 pieces. After i fix this i have decided to take the intake off to fix a fuel leak that i can smell but cant see. So i have alot of work ahead of me but i need to get this taken care of. Then i'll start on the leak and then im done. Please help!

sorry, i was very angry when i wrote this. I've got it fixed now thankfully, i had to pry that pipe loose from a stud on the side of the truck behind the kick panel. After that it moved away enough to remove that cover (after removing the ECM, and the ECMs mounting bracket so that i could unhook it from the hook on the top. That gave me the clearance i needed to remove the cover and motor. Changed out the motors and put it all back together and all is good now. Woohoo!