Yeah i was wondering if anyone could tell me how to get the injectors out of my lb7. i could prolly do it myself but i dont want to miss anything. i would like to get them honed pretty quick so any help would be great.

you need to pull the valve covers not one of the easiest jobs but deffinatly doable

Jared

Basically strip the front and top of your engine. I almost got to that point while doing the CP3 swap. Be sure to lable all of the bolts/parts you pull out and have plenty of new o-rings ready to put it all back together. There aren't any really good instructions out there, but I could get you to the point of pulling the hard lines.

Basically strip the front and top of your engine. I almost got to that point while doing the CP3 swap. Be sure to lable all of the bolts/parts you pull out and have plenty of new o-rings ready to put it all back together. There aren't any really good instructions out there, but I could get you to the point of pulling the hard lines.

if u can get me there that would be great. i thought the lb7 were tougher then the others.

if u can get me there that would be great. i thought the lb7 were tougher then the others.

When are you planning on doing it? I had the "best" instructions available, but they weren't a lot of help. So I was working on a detailed DIY until it ended up just being a million little bolts/o-rings. PM your email and I can send a pdf of the crappy instructions that any shop will give you. Once you start working through it, you could give me a call whenever you hit tough spots.