i have a ready lift in my truck and i am trying to align it but not enough camber adjustment anyone have any ideas what to do.:mad:

I think that is one of the reasons the Cognito UCA kit is so popular. Check out this link.
http://www.norcaltruck.com/cognito-2-3.html

What are your alignment measurements on both sides?

i aligned it at work all in the green except the caster but that wont cause tire wear so it is good now driver side was good the way it was never adjusted but the pass side was out about 1.73 toe was out a little runs great down the road almost like a solid axel is under there and works great with the plow on

sometimes with a lift like that you wont get all adjustments in the green. You need to focus on camber and toe, and set your cross caster to -0.7 degrees (or close too) and you should be good to go.