I've been doing a bunch of stuff to my truck and the project is nearing completion. I've got this shield, I think it goes on the RH side in the fender well somewhere. Anybody recognize it or can shoot a picture of it installed?

Thanks in advance!
Regards,
Mike

goes in the fenderwell area. ED

goes in the fenderwell area. ED

OK, well, I know that.... exactly , where in the fenderwell area does it go?

I always wanted to use this one...
:nopics:

Thanks,
Mike

To Me that looks like the splash guard that goes over your upper control arm.
Gets in the way when doing glow plugs and starter wiring.:cussing:

The splash guard over the upper A is more round on top and symetrical.

I believe it may go in passanger side fender well on front. I took mine off last time I took fender out and did not see it in garage to compare:rolleyes:. I tried to look at LMC truck and it looked different there too. The piece might be different for different years??? Or it was a generic pic on LMC.

Here's where I think it goes. I think it tries to retard water from getting to snorkel inlet area. You can see some holes for the push lock keepers. You have to take it off to get to that little screw for the lower trim on grill iirc.

The splash guard over the upper A is more round on top and symetrical.

I believe it may go in passanger side fender well on front. I took mine off last time I took fender out and did not see it in garage to compare:rolleyes:. I tried to look at LMC truck and it looked different there too. The piece might be different for different years??? Or it was a generic pic on LMC.

Here's where I think it goes. I think it tries to retard water from getting to snorkel inlet area. You can see some holes for the push lock keepers. You have to take it off to get to that little screw for the lower trim on grill iirc.

X2

The splash guard over the upper A is more round on top and symetrical.

I believe it may go in passanger side fender well on front. I took mine off last time I took fender out and did not see it in garage to compare:rolleyes:. I tried to look at LMC truck and it looked different there too. The piece might be different for different years??? Or it was a generic pic on LMC.

Here's where I think it goes. I think it tries to retard water from getting to snorkel inlet area. You can see some holes for the push lock keepers. You have to take it off to get to that little screw for the lower trim on grill iirc.

I see two holes facing forward, you think that's where it might go? I'll try that and see how it fits.

Thanks,
Mike