Guys - where have you found sources for angle wrenches? Have seen on the site that this tool is about the only way to get the injection lines off the pump. I'm struggling to find them anywhere locally.

I got my lines off with regular ones, it wasnt fun but I was able to do it...

I managed to get mine off using just a 3/4" open-end wrench, but the last couple were a serious PITA. I went down and bought a set of 3/8" drive crows-foot wrenches -- the flare-nut type -- to put it back together again. I haven't actually gotten to the point of putting it back together yet -- one thing led to another while I had it torn down, and I'm replacing the rocker-arm retainers, and some other stuff -- to see if those make a big difference, or if it's still a PITA. :rolleyes:

ebay look for snap-on, mac, proto, etc.

Regular old crows foot work like a charm. 16mm or 5/8" IIRC on the pump.

I have gotten good service and products from an online store called Tool Ware House. You can find some angled wrenches for sale on here: http://www.thetoolwarehouse.net/shop/SUN-9914M.html. If that is not quite right they have some others to select from.