BigWill_21
12-30-2004, 02:18 PM
I didn't notice i had left the Edge on Level 5 and took off from light to pass a few slow cars and a lady who couldn't shift a Manual tranny and was blocking traffic...
The truck bucked and it dropped to what I guess was 3rd gear and wouldn't go to a higher gear, SES light came on immediately!!!! I was going about 60 and it BUCKED during the 4-5 shift...
I stopped and parked it cut it on and off 3 times and it drove fine but light was on... Light went off after a day!!!
Went and used a SNAP-ON Scan Tool, it read it though ti was only for up to 2003 and gave a P0746 code... and some weirde message although it did say it cleared the TRANNY CODE...
ANYONE KNOW IF I REALY CLEARED IT???? or what this code is????? I won't have my own NEW SCAN-TOOL stuff until later this week when ti and our new EMMISION COMPUTER SETup IS DELIVERED...
WHAT SHOULD I DO??
THANKS
WILL
The truck bucked and it dropped to what I guess was 3rd gear and wouldn't go to a higher gear, SES light came on immediately!!!! I was going about 60 and it BUCKED during the 4-5 shift...
I stopped and parked it cut it on and off 3 times and it drove fine but light was on... Light went off after a day!!!
Went and used a SNAP-ON Scan Tool, it read it though ti was only for up to 2003 and gave a P0746 code... and some weirde message although it did say it cleared the TRANNY CODE...
ANYONE KNOW IF I REALY CLEARED IT???? or what this code is????? I won't have my own NEW SCAN-TOOL stuff until later this week when ti and our new EMMISION COMPUTER SETup IS DELIVERED...
WHAT SHOULD I DO??
THANKS
WILL