|
6speedduramax 12-29-2007, 08:02 PM Going to do rods come spring....wanting to go ahead and do what needs done inside to be safe with around 800 hp if I ever get there.:rolleyes: So what all other than rods needs done to the engine to make it strong enough for 800 hp? 01Duramax6spd 12-29-2007, 08:23 PM Good question. Me too :D. 6speedduramax 12-30-2007, 10:42 AM ttt dmaxalliTech 12-30-2007, 10:57 AM see my garage.....been there, done that 6speedduramax 12-30-2007, 11:02 AM I was hoping the list would be MUCH shorter then that....:( dmaxalliTech 12-30-2007, 11:06 AM the "for sures" for mechanicals Main studs Head studs cut pistons keyed cam and crank deck block deck heads rods torque plate hone ( better ring seal) balance recommended The rest depends on where you plan on making that power. My setup does it at 3600-3800 rpm. pushrods valve bridges So Cal Spring kit So Cal Cam turbo and fuel sparky1562 12-30-2007, 11:11 AM Eric, it's too cold in Michigan, you need to set up shop in Middle Tennessee. :rolleyes: dmaxalliTech 12-30-2007, 11:14 AM customer in Sevierville swears he is building me one.... ZF6 MAN 12-31-2007, 09:18 AM the "for sures" for mechanicals Main studs Head studs cut pistons keyed cam and crank deck block deck heads rods torque plate hone ( better ring seal) balance recommended The rest depends on where you plan on making that power. My setup does it at 3600-3800 rpm. pushrods valve bridges So Cal Spring kit So Cal Cam turbo and fuel Can you say Powerball Lottery? fbh31118 12-31-2007, 10:22 AM Eric, it's too cold in Michigan, you need to set up shop in Middle Tennessee. :rolleyes: Eric is ours (Michigan) and you can't have him! :D Holland is too short a drive from the Kazoo. sparky1562 12-31-2007, 12:56 PM :bawl:Eric is ours (Michigan) and you can't have him! :D Holland is too short a drive from the Kazoo. | ||