saw a member here that has his/her exhaust exid in fron of the rear wheel, and before the rear shackel of the leaf springs. my questiuon is how can i do that? my current banks cat back rubs on my airbags and i dont want any danger of them poppin.
thanks

crank a 90* bend into the pipe before the wheel....??? Hammer4 has a side dump on his, might shoot him a pm, ask how he did it.

My friend did it, but we used a long 5" stack and had it as about a 45* before the tire. Luckily you have black wheels.

Sounds like that could get a little messy

Sounds like that could get a little messy

haha im all stock untill mike l get alli a present this christmas!

:nopics:

Heres some pics of mine!


http://dieselplace.com/forum/showpost.php?p=1825765&postcount=2

i made this using a MBRP front pipe and 2- 45* bends cut short and welded and a 60* bend to get out the side!

The muffler is a Borla 4" stainless pro sportsman oval muffler from Summit. Its straight through, with stainless steel wool type packing around the walls!

i took my exhaust cut it 11inches befor the curve of the frame threw on a 45degree angle pipe and bam 6inch tip custom exhaust...looks good mad hatter muffler in mesa welded it on for me but you can clamp it like i previously did

I have a side exit...pic's in my garage..and yep, if you smoke alot, it does get sorta messy :D

ask Mcrat, Pat has side exit exhaust in front of his RR wheel. he or Kat have plenty of pics also

I helped my buddy put a 6" shottie out the side of his truck before the rear wheel. its a cakewalk. PM RENODMAX for the specifics.

i did a 90* right after the stock hanger on stock exhaust.. werethe muffle normally attached. then to the last 22" oif the tail pipe and made a tip to get it past the body

here is a shot of mine back when it was stock. i just used a piece of tailpipe and went right after the carrier bearing crossmember then ran another hanger off the frame.

http://www.dieselplace.com/forum/garageimage.php?do=full&p=45092&d=1196903505

just be ready to clean your wheel once a week.

http://dieselplace.com/forum/showthread.php?t=162434&page=2

I showed my brother's here. It's a 5" magnaflow ss409 that has been special cut and welded with a 6" x 24" exhaust tip.

I keep tell exhaust companies there is a market for this, and they refuse to make these.

Hangs a little low, but no soot on the tire/rim/body.

Using a 4" MBRP cat delete in the fornt, stock 3.5 after that. I just used a stock exhaust from another donor truck. Donor truck was a CCSB, and mine is a ECLB, so I had to extend it so it would dump in front of the rear wheel.

http://i6.photobucket.com/albums/y225/NorCalPR/DmaxExhaust/P1030001.jpg

http://i6.photobucket.com/albums/y225/NorCalPR/DmaxExhaust/P1030004.jpg

http://i6.photobucket.com/albums/y225/NorCalPR/DmaxExhaust/P1030006.jpg

http://i6.photobucket.com/albums/y225/NorCalPR/DmaxExhaust/P1030002.jpg


My buddy has a 06 and he dumped it right after the rear diff. Points down. He basically cut the 90 degree piece off that makes it a size exit and jsut installed a tip. You can hardly see that anything's there.