they are spec'd out a little bigger than H2s and i rubbed a little with the H2s in reverse a time or two... is anyone running them? can they fit with just cranking and trimming (only plastic)

i want to put detata platoon's and nitto terra grapplers on in the 325 flavor but i'd like them to fit without a lift so i can fit in a garage

anyone have pics of this size on a d-max?

Is this going on an H2? I'd say crank the torsion bars up about 3-4 turns. They should fit no prob. Factory's are 315's, right?

the wheels and tires are designed for an h2, i was wondering if anyone has put them on an HD, i had the h2 wheels and tires, i cranked my t-bars 8 turns already, i dont have much down travel left.


http://imagehost.vendio.com/bin/imageserver.x/00000000/crowderscustomizing/Detata_Platoon_Vehicle_2.JPG

Ahh! I'd say there is no chance in hell they will fit. The biggest you can go with out a lift and even tighting the bars up are 285's (33"). Off Road Unlimited now sells a leveling kit for the HD's. Raises the front 2-2.5 inches and is only $70. And it doesn't wear your tires out funny, and retains factory ride. All you need is to have an alignment down afterwards and you need longer shocks. So figure on about $200 for all of it. I'm going to do it soon. And even with all that lift the biggest tire you can put on is a 305 (about a 34" tire) The 325's are about a 37" You will def. need a 6-8" lift for that, or you will have some big problems.

The 325/60R20 (35.4") are about 1" taller than the H2´s 315/70R17 (34.4")tires. You might want to look into Toyo´s Open Country AT´s in a 325/50R20 size...only 32.8" tall as compared to the 34.4" of the H2´s. Other choices would be 305/55R20 - 33.2" tall (Toyo, Nitto), a 275/60R20 - 33" tall (Toyo, GoodYear) or the Interco IROK 33x13.5-20