I bought my 02 used and cannot get it to go into progrm mode so I can program keyless entry fob. I get into mode on my 2000 but this one wont do the lock unlock to tell you its ready.Any ideas where to start and where is the keyless module.

All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to four transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.



You may program up to 4 transmitters, using either of the two following procedures:

Transmitter Programming Procedure (Method 1 - No Tools Required) <LI type=1>Close all the vehicle doors. <LI type=1>Insert the ignition key into the ignition lock cylinder. <LI type=1>Press and hold the door unlock switch. <LI type=1>While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. <LI type=1>Release the door unlock switch. The doors will lock and unlock to confirm the program mode. <LI type=1>Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter. <LI type=1>Repeat the previous step to program up to four transmitters. <LI type=1>Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation.

It will not do step 6 to confirm its in program mode. I do it on my other gm and it confirms so I know I am doing it right.

It will not do step 6 to confirm its in program mode. I do it on my other gm and it confirms so I know I am doing it right.I would try it with a Tech 2 then.

I will go try that next thank you.