Anybody know which lifts are compatible with H2's and 315's. Either 4" or 6" CST,FABTech, RCD, Rancho or other. - Thanks

I'M NOT SURE I WOULD THNK ANY OF THEM I HAVE H2'S WITH 315'S ON MY TRUCK AND NO RUBBING HAD TO TURN THE TORSIONS UP SOME BUT NOT EVEN CLOSE TO MAXED OUT....I PUT SOME SPACERS ON MY FRONT SHOCKS BECAUSE I RAISED THE TRUCK 1 1/4 INCHES RIDES VERY NICE AND NO PROBLEM WITH BUMPS.......So UNLESS U JUST WANT TO PUT A LIFT ON THERE IS REALLY NO NEED, IF YOU GOT THE BUCKS THEN GO FOR IT I'M SURE OTHERS WILL CHIME IN THAT ACTUALLY KNOW LIFTS..

Looking to see if anybody has tried to fit h2's on a 6" spindel lift because of the high wheel offset. - Thanks

I don't think it works with any that I'm aware of. Spindle lifts wont work with H2's as far as I know, like you said, 5.5" offset is too much.

The CST 6 inch is not a spindle lift. Its a full drop down lift. They have a complete subframe that drops everything down a full 6 inches. I like it and I'm happy with mine. You might squeeze those big tires in there without it, but what if you need to jump it? ):h

Seriously though, if you do the 6 inch, I don't think you would be limited to 35's although that's what it calls for and what I run. I could fit 38's in there and have plently of room.

CST is a little spendy for most, but after looking over others I decided it was the best for me. Considering what these trucks cost, seems petty to quibble over a couple of bucks when it comes time to lift it.

H2 wheels will not work with RCD, the tires will though ):h

So, Chisuzu, what is the $ on the CST 6" lift? Sounds like what I want. There are no nearby dealers in Montana or Wyoming. Looks like their closest are in Colorado or Utah. Did you do your own install? And if so, how would you rate it's difficulty to install? I've keeping my eyes open, too, for a lift and H2's. This may be the way for me. Comments?

BB

CottonWoodBlues,
As for price, I know some of there stuff changed a little and so did the price, so I would hate to say one thing to find out its another. I had it installed in Utah. Went to Lancer's. You can find their contact info on the CST website.

So the CST lift is the only one that will work with H2s? I just took mine off because I get bad rubbing during slight offroading (I just have green keys and lots of trimming). Got the stocker 245's back on until I can get a lift on, and have been researching for the past few days. Is there a website where I can prder the kit online?

TTT?

anyone?

is the CST the only lift for H2's?

I don't really undersand the whole offset thing