How did you guys rout the wire from the monitor to the box? I ran mine like the instructions said to but I am worried about the door continuously pinching the cable....

I ran mine through a hole in the firewall, looks much better than out the door.

I also ran mine through the hole in the firewall.

I used the door but will be sliding it through the firewall when I have a chance.

I ran mine through a hole in the firewall, looks much better than out the door.
What hole did you use? Sounds kinda like a personal question, I know.....lol

There is a pretty good size rubber grommet. Open the hood and look down on the drivers side of the vehicle, it is behind the battery and a good ways down. I cut a hole with a box cutter, and pushed the wire through. Hope that helps

Hope you have skinny arms, i had to get my brother to reach his hand down there and cut the hole, my arm wouldnt fit down in there

Hope you have skinny arms, i had to get my brother to reach his hand down there and cut the hole, my arm wouldnt fit down in there

I don't goto the gym, I'll be all set :)

I drilled a new hole and put a gromet in. I also ran my attitude to my overhead center counsel.

They have it routed that way because they anticipate you removing it shortly after installation with prejudice.

:blahblah:

wtf how did u guys get edge ??

Any problems with your juice with attitude...........I ran into a whole bunch of problems and am sending it back.........

Walsh, I got mine as a beta tester. I'm sending it back due to some glitches in the system. I have the PPE tuner and love it. The PPE made way more power.