|
gonefishing669 07-01-2007, 02:42 PM hi, i have a 93 GM 6.5 TD.... when i turn the wipers on,they usually work fine....some times the itermitten works ,then i put it on low speed.. that don`t work ..put the wipers on high and that works..but most times only the high speed works,and sometimes they quit altogather, and usually during the worst times...every thing else on the switch seems to be fine....cruise,window wash high and low beam switch.... heymccall 07-01-2007, 07:27 PM The wiper motor circuit board has unsoldered itself. GM had a nationwide recall on these, but if GM says "you're not covered", either solder it yourself or replace the circuit board. Remove the wiper motor plug, removed the 3 Torx screws (don't drop them:rolleyes: ), set the dust cover aside, and wiggle the board out of the motor assembly. Solder the cracked solder joints or replace the board. Installation is the reverse. gonefishing669 07-01-2007, 08:41 PM ok thanks i will give GM a call this week and see....ant idea on the price of a new curcuit boad... and thanks for the advice Dieseldad97 07-01-2007, 08:47 PM ok thanks i will give GM a call this week and see....ant idea on the price of a new curcuit boad... and thanks for the advice I fixed a wiper board a few years back on my '92 chevy. Not a big deal doing it yourself. Take your time and just flex the board from side to side and study it....you should see the crack. Then just re-solder it. Worked great for the 4 years I owned the truck. A new board here in Canada was $90 bucks at the time. They may be less now....or more. Good luck. :) boondokr 07-01-2007, 08:52 PM X2. but I replaced the board before I found out about the solder joint problems. gonefishing669 07-02-2007, 05:18 AM i`ll take it apart tomorrow and try to fix her. Rttoys 07-02-2007, 04:08 PM I've had good luck with Motormite wiper modules- part #88136 cost $20. | ||