somekevinguy
10-30-2003, 12:42 AM
I have always like Mobil 1 products and it seems like a lot of you use the Moblil 1 Delvac oil but what about their ATF. I keep reading about transynd. Is it beter than Mobil 1? Also I saw some post about taking off some trans line and flushing the trans when switching over. That seems like a pain. Is there really that much left in there or is it adequate to just drain the pan. While I am at it what does the deeper pan do for you? Obviously more fluid but what is the advantage to that? Cooling?
Mackin
10-30-2003, 07:23 AM
While I am at it what does the deeper pan do for you? Obviously more fluid but what is the advantage to that? Cooling?
Yes, and with added capacity longer drain intervals ....
I'm running Mobil I dino .... Trynsnd is a synthetic .... Synthetics offer extended drain intervals and will with stand greater heat before breaking down ....
The flush method is the only way to completely (or close to it) the Converter and cooler when swapping fluid .... You could do it two or three times in succession too but it will cost .....
Swapping to Transynd,I would flush .... It isn't hard at all .....There is plenty of info here to accomplish with support ....
* Sorry Eric thought I'd give you a break *
Mac http://www.dieselplace.com/forum/smileys/Approve.gif Edited by: Mackin
somekevinguy
10-31-2003, 10:06 AM
I thought the Mobil 1 ATF was synthetic also. I thought all Mobil 1 products were synthetics or they would just be called Mobil.